Rscn Event-Tov - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

rscn event-tov

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
rscn event-tov
To configure an event timeout value for a Registered State Change Notification (RSCN) on a specified
VSAN, use the rscn event-tov command. To cancel the event timeout value and restore the default value,
use the no form of the command.
Syntax Description
timeout
vsan vsan-id
Command Default The default timeout values are 2000 milliseconds for Fibre Channel VSANs.
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines Before changing the timeout value, you must enable RSCN configuration distribution using the rscn
distribute command.
The RSCN timer is registered with Cisco Fabric Services (CFS) during initialization and switchover.
Examples The following example configures an RSCN event timeout value on VSAN 1:
switch(config)# rscn event-tov 20 vsan 1
Related Commands Command
rscn abort
rscn commit
rscn distribute
clear rscn session
show rscn
Cisco Nexus 5000 Series Command Reference
8-126
rscn event-tov timeout vsan vsan-id
no rscn event-tov timeout vsan vsan-id
Specifies an event timeout value in milliseconds. The range is 0 to 2000.
Specifies a VSAN where the RSCN event timer should be used. The ID of
the VSAN is from 1 to 4093.
Modification
This command was introduced.
Description
Cancels a pending RSCN configuration on a specified VSAN.
Applies a pending RSCN configuration.
Enables distribution of an RSCN configuration.
Clears the RSCN session for a specified VSAN.
Displays RSCN configuration information.
Chapter 8 Fibre Channel Commands
OL-16599-01