Show Sprom - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 1 Basic System Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

show sprom

To display the contents of the serial PROM (SPROM) on the switch, use the show sprom command.
Syntax Description all
backplane
fex
chassis_ID
module module-number Displays the SPROM contents for a I/O module. The module number range
powersupply ps-num
sup
Command Default None
Command Modes
EXEC mode
Command History Release
4.0(0)N1(1a)
4.0(1a)N2(1)
Usage Guidelines
The SPROM on the switch contains detailed information about the hardware, including serial, part, and
revision numbers. If you need to report a problem with a system component, you can extract serial
number information using the show sprom command.
Examples
This example shows how to display SPROM information for all components on the physical device:
switch# show sprom all
This example shows how to display SPROM information for the backplane:
switch# show sprom backplane
This example shows how to display SPROM information for an attached Fabric Extender:
switch# show sprom fex 101
OL-16599-01
show sprom {all | backplane | fex {chassis_ID {all | backplane | powersupply ps-num} | all} |
module module-number | powersupply ps-num | sup}
Displays the SPROM contents for all components on the physical device.
Displays the SPROM contents for the backplane.
(Optional) Displays information about the attached Fabric Extender units.
(Optional) Specifies a Fabric Extender chassis ID. Chassis ID is 100 to 199.
is from 1 to 3.
Displays the SPROM contents for a power supply. The power supply number
range is 1 or 2.
Displays the SPROM contents for the active supervisor module.
Modification
This command was introduced.
This command was modified to provide Fabric Extender support.
Cisco Nexus 5000 Series Command Reference
show sprom
1-101