Fcsp - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

fcsp

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
fcsp
To configure an Fibre Channel Security Protocol (FC-SP) authentication mode for a specific interface in
a FC-SP-enabled switch, use the fcsp command. To disable an FC-SP on the interface, use the no form
of the command.
Syntax Description
auto-active
auto-passive
on
off
timeout-period
Command Default Auto-passive mode
Command Modes Interface configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines To use this command, FC-SP must be enabled using the fcsp enable command.
Examples
The following example turns on the authentication mode for Fibre Channel interface in port 1 of slot 2:
switch(config)# interface fc 2/1
switch(config-if)# fcsp on
switch(config-if)#
The following example reverts to the factory default of auto-passive for the selected interface:
switch(config-if)# no fcsp
The following example changes the selected interface to initiate FC-SP authentication, but does not
permit reaunthentication:
switch(config-if)# fcsp auto-active 0
Cisco Nexus 5000 Series Command Reference
8-68
fcsp {auto-active | auto-passive | on | off} [timeout-period]
no fcsp
Configures the auto-active mode to authenticate the specified interface.
Configures the auto-passive mode to authenticate the specified interface.
Configures the on mode to authenticate the specified interface.
Configures the off mode to authenticate the specified interface.
(Optional) Specifies the time out period to reauthenticate the interface. The
time ranges from 0 (default—no authentication is performed) to 100,000
minutes.
Modification
This command was introduced.
Chapter 8 Fibre Channel Commands
OL-16599-01