End - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 1 Basic System Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

end

To end the current configuration session and return to EXEC mode, use the end command in
configuration mode.
Syntax Description This command has no arguments or keywords.
Command Default
None
Command Modes
Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines
This command returns you to EXEC mode regardless of which configuration mode you are in. Use this
command when you are done configuring the system and you want to return to EXEC mode to perform
verification steps.
Examples
In the following example, the end command is used to exit from interface configuration mode and return
to EXEC mode. A show command is used to verify the configuration.
switch# configure terminal
switch(config)# interface ethernet 1/1
switch(config-if)# switchport host
switch(config-if)# end
switch# show interface ethernet 1/1
Related Commands Command
exit (EXEC)
exit (global)
OL-16599-01
end
Modification
This command was introduced.
Description
Terminates the active terminal session by logging off the router.
Exits from the current configuration mode.
Cisco Nexus 5000 Series Command Reference
end
1-33