Show Vpc Role - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

show vpc role

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
show vpc role
To display information about the virtual port-channel (vPC) role of the peer device, use the show vpc
role command.
Syntax Description This command has no arguments or keywords.
Defaults
None
Command Modes
Any command mode.
Command History Release
4.1(3)N1(1)
Usage Guidelines
The show vpc role command displays the following information about the vPC status:
•
•
•
•
•
•
This command is not available if you have not enabled the vPC feature. See feature vpc for information
on enabling vPCs.
This command does not require a license.
Examples This example shows how to display the vPC role information of the device that you are working on:
switch (config)# show vpc role
Primary:
vPC Role status
----------------------------------------------------
vPC role
Dual Active Detection Status
vPC system-mac
vPC system-priority
vPC local system-mac
vPC local role-priority
Cisco Nexus 5000 Series Command Reference
10-16
show vpc role
Modification
This command was introduced.
Status of peer adjacency
vPC role of the VDC that you are working on
vPC MAC address
vPC system priority
MAC address of the device that you are working on
System priority for the device that you are working on
: primary
: 0
: 00:23:04:ee:be:01
: 32667
: 00:22:55:79:ea:c1
: 32667
Chapter 10 Vpc Commands
OL-16599-01