Logging Event Port - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 7 System Management Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

logging event port

Use the logging event port command to log events on an interface. To disable logging of interface
events, use the no form of this command.
logging event port {link-status | trunk-status} [default]
no logging event port {link-status | trunk-status}
Syntax Description link-status
trunk-status
default
Command Default
None
Command Modes Interface configuration mode
Command History Release
4.0(0)N1(1a)
Examples
This example shows how to log interface events:
switch# configure terminal
switch(config)# interface ethernet 1/1
switch(config-if)# logging event port link-status default
Related Commands Command
show interface
show logging
OL-16599-01
Log all UP/DOWN and CHANGE messages.
Log all TRUNK status messages.
(Optional) The default logging configuration is used by interfaces not
explicitly configured.
Modification
This command was introduced.
Description
Displays the interface configuration information.
Displays the logging status.
Cisco Nexus 5000 Series Command Reference
logging event port
7-9