Show Rscn - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 9 Fibre Channel Show Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

show rscn

To display Registered State Change Notification (RSCN) information, use the show rscn command.
Syntax Description event-tov
vsan vsan-id
pending
pending-diff
scr-table
session status
statistics
Command Default
None
Command Modes EXEC mode.
Command History Release
4.0(0)N1(1a)
Usage Guidelines
The SCR table cannot be configured. It is only populated if one or more N ports send SCR frames to
register for RSCN information. If the show rscn scr-table command does not return any entries, no N
port is interested in receiving RSCN information.
Examples
The following example displays RSCN information:
switch# show rscn scr-table vsan 1
The following example displays RSCN statistics:
switch# show rscn statistics vsan 1
The following example shows the RSCN event timeout value configured on VSAN 1:
switch# show rscn event-tov vsan 1
The following example shows the difference between the active RSCN configuration and the pending
RSCN configuration on VSAN 1:
switch# show rscn pending-diff vsan 1
OL-16599-01
show rscn {event-tov vsan vsan-id | pending vsan vsan-id | pending-diff vsan vsan-id | scr-table
[vsan vsan-id] | session status vsan vsan-id | statistics [vsan vsan-id]}
Displays the event timeout value.
Specifies a VSAN ID. The range is 1 to 4093.
Displays the pending configuration.
Displays the difference between the active and the pending configuration.
Displays the State Change Registration (SCR) table.
Displays RSCN session status.
Displays RSCN statistics.
Modification
This command was introduced.
Cisco Nexus 5000 Series Command Reference
show rscn
9-41