Fspf Enable - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 8 Fibre Channel Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

fspf enable

To enable FSPF for a VSAN, use the fspf enable command. To disable FSPF routing protocols, use the
no form of the command.
Syntax Description
vsan vsan-id
Command Default Enabled.
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines This command configures FSPF on VSANs globally.
Examples The following example enables FSPF in VSAN 5 and disables FSPF in VSAN 7:
switch(config)# fspf enable vsan 5
switch(config)# no fspf enable vsan 7
Related Commands Command
fspf config vsan
show fspf interface
OL-16599-01
fspf enable vsan vsan-id
no fspf enable vsan vsan-id
Specifies a VSAN ID. The range is 1 to 4093.
Modification
This command was introduced.
Description
Configures FSPF features for a VSAN.
Displays information for each selected interface.
Cisco Nexus 5000 Series Command Reference
fspf enable
8-85