Fcsp Enable - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

fcsp enable

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
fcsp enable
To enable the Fibre Channel Security Protocol (FC-SP) in a switch, use the fcsp enable command.
Additional FC-SP commands are available when the FC-SP feature is enabled. To disable FC-SP, use the
no form of the command.
Syntax Descriptionf
fcsp
enable
Command Default Disabled.
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Examples The following example enables FC-SP:
switch(config)# fcsp enable
Related Commands Command
show fcsp
Cisco Nexus 5000 Series Command Reference
8-72
fcsp enable
no fcsp enable
Specifies the FC-SP feature in the switch.
Enables the FC-SP feature in this switch.
Modification
This command was introduced.
Description
Displays configured FC-SP information.
Chapter 8 Fibre Channel Commands
OL-16599-01