Fabric-Binding Activate - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

fabric-binding activate

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
fabric-binding activate
To activate fabric binding in a VSAN, use the fabric-binding activate command. To disable this feature,
use the no form of the command.
Syntax Description
vsan vsan-id
force
Command Default Disabled.
Command Modes
Configuration mode
Command History Release
4.0(0)N1(1a)
Examples The following example activates the fabric binding database for the specified VSAN:
switch(config)# fabric-binding activate vsan 1
The following example deactivates the fabric binding database for the specified VSAN:
switch(config)# no fabric-binding activate vsan 10
The following example forcefully activates the fabric binding database for the specified VSAN
switch(config)# fabric-binding activate vsan 3 force
The following example reverts to the previously configured state or to the factory default (if no state is
configured):
switch(config)# no fabric-binding activate vsan 1 force
Related Commands Command
fabric-binding
database
fabric-binding enable
Cisco Nexus 5000 Series Command Reference
8-38
fabric-binding activate vsan vsan-id [force]
no fabric-binding activate vsan vsan-id
Specifies the VSAN. The ID of the VSAN is from 1 to 4093.
(Optional) Forces fabric binding activation.
Modification
This command was introduced.
Description
Configures a fabric-binding database.
Enables fabric-binding.
Chapter 8 Fibre Channel Commands
OL-16599-01