Lacp System-Priority - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 2 Ethernet Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

lacp system-priority

To set the system priority of the switch for the Link Aggregation Control Protocol (LACP), use the lacp
system-priority command. To return the system priority to the default value, use the no form of this
command.
Syntax Description
priority
Command Default
System priority value is 32768.
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines
Each device that runs LACP has an LACP system priority value. You can configure a value between 1
and 65535. LACP uses the system priority with the MAC address to form the system ID and also during
negotiation with other systems.
When setting the priority, note that a higher number means a lower priority.
Examples
This example shows how to set the LACP system priority for the device to 2500:
switch(config)# lacp system-priority 2500
Related Commands Command
show lacp
OL-16599-01
lacp system-priority priority
no lacp system-priority
Priority for the physical interfaces. The range of valid numbers is from 1 to
65535.
Modification
This command was introduced.
Description
Displays LACP information.
Cisco Nexus 5000 Series Command Reference
lacp system-priority
2-27