Speed (Ethernet) - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 2 Ethernet Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

speed (Ethernet)

To configure the transmit and receive speed for an Ethernet interface, use the speed command. To reset
to the default speed, use the no form of this command.
Syntax Description
1000
10000
Command Default The default speed is 10000 (10-Gigabit)
Command Modes
Interface configuration mode
Command History Release
4.0(1a)N1(1)
Usage Guidelines The first 8 ports of a Nexus 5010 switch and the first 16 ports of a Nexus 5020 switch are switchable
1-Gigabit and 10-Gigabit ports. The default interface speed is 10-Gigabit. To configure these ports for
1-Gigabit Ethernet, insert a 1-Gigabit Ethernet SFP transceiver into the applicable port and then set its
speed with the speed command.
If the interface and transceiver speed is mismatched, the SFP validation failed message is displayed when
Note
you enter the show interface ethernet slot/port command. For example, if you insert a 1-Gigabit SFP
transceiver into a port without configuring the speed 1000 command, you will get this error.
By default, all ports on a Cisco Nexus 5000 Series switch are 10 Gigabits.
Examples The following example shows how to to set the speed for a 1-Gigabit Ethernet port:
switch# configure terminal
switch(config)# interface ethernet 1/1
switch(config-if)# speed 1000
Related Commands Command
show interface
OL-16599-01
speed {1000 | 10000}
no speed
Sets the interface speed to 1-Gigabit.
Sets the interface speed to 10-Gigabit. This is the default speed.
Modification
This command was introduced.
Description
Displays the interface configuration information.
Cisco Nexus 5000 Series Command Reference
speed (Ethernet)
2-89