Udld (Ethernet) - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

udld (Ethernet)

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
udld (Ethernet)
To enable and configure the Unidirectional Link Detection (UDLD) protocol on an Ethernet interface,
use the udld command. To disable UDLD, use the no form of this command.
Syntax Description
aggressive
disable
enable
Command Modes Interface configuration mode
Command History Release
4.0(1a)N1(1)
Usage Guidelines You can configure normal or aggressive UDLD modes for an Ethernet interface. Before you can enable
a UDLD mode for an interface, you must make sure that UDLD is enabled on the switch. UDLD must
also be enabled on the other linked interface and its device.
To use the normal UDLD mode on a link, you must configure one of the ports for normal mode and
configure the port on the other end for the normal or aggressive mode. To use the aggressive UDLD
mode, you must configure both ends of the link for aggressive mode.
Examples
The following example shows how to enable the normal UDLD mode for an Ethernet port:
switch# configure terminal
switch(config)# interface ethernet 1/1
switch(config-if)# udld enable
This example shows how to enable the aggressive UDLD mode for an Ethernet port:
switch(config-if)# udld aggressive
This example shows how to disable UDLD for an Ethernet port:
switch(config-if)# udld disable
Related Commands Command
show udld
Cisco Nexus 5000 Series Command Reference
2-102
udld {aggressive | disable | enable}
no udld {aggressive | disable | enable}
Enables UDLD in aggressive mode on the interface.
Disables UDLD on the interface.
Enables UDLD in normal mode on the interface.
Modification
This command was introduced.
Description
Displays the administrative and operational UDLD status.
Chapter 2 Ethernet Commands
OL-16599-01