Chapter 8
Fibre Channel Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
rscn abort
To cancel a Registered State Change Notification (RSCN) configuration on a VSAN, use the rscn abort
command. To reverse the cancellation, use the no form of the command.
Syntax Description
vsan vsan-id
Command Default
None
Command Modes
Configuration mode
Command History
Release
4.0(0)N1(1a)
Examples
The following example cancels an RSCN configuration on VSAN 1:
switch(config)# rscn abort vsan 1
Related Commands
Command
rscn commit
rscn distribute
rscn event-tov
clear rscn session vsan Clears the RSCN session for a specified VSAN.
show rscn
OL-16599-01
rscn abort vsan vsan-id
no rscn abort vsan vsan-id
Specifies a VSAN where the RSCN configuration should be cancelled. The
ID of the VSAN is from 1 to 4093.
Modification
This command was introduced.
Description
Commits a pending RSCN configuration on a specified VSAN.
Enables the distribution of an RSCN configuration.
Configures an RSCN event timeout.
Displays RSCN configuration information.
Cisco Nexus 5000 Series Command Reference
rscn abort
8-123