Match Precedence - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

match precedence

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
match precedence
To configure a class map to use the precedence value in the Type of Service (TOS) byte field of the IP
header as a match criteria, use the match precedence command. To remove the precedence values as a
match criteria, use the no form of this command.
Syntax Description
not
precedence-list
Defaults None
Command Modes Class-map type qos configuration
Command History Release
4.1(3)N1(1)
Usage Guidelines See
Table 2
<0-7>
critical
flash
flash-override
immediate
internet
network
priority
routine
To specify a list of values, use one of the following options:
•
•
Cisco Nexus 5000 Series Command Reference
5-12
match [not] precedence precedence-list
no match [not] precedence precedence-list
(Optional) Negates the specified match result.
Matches on the specified IP precedence value or list of IP precedence
values specified in bytes. Valid values are shown in
Modification
This command was introduced.
Table 2 for a list of precedence values.
Precedence Values
List of Precedence Values
IP precedence value
Critical precedence (5)
Flash precedence (3)
Flash override precedence (4)
Immediate precedence (2)
Internetwork control precedence (6)
Network control precedence (7)
Priority precedence (1)
Routine precedence (0)
Specify a range of values separated by a dash
Specify a noncontiguous list of values separated by commas
Chapter 5 Quality of Service Commands
Table 2.
OL-16599-01