Rscn Commit - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

rscn commit

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
rscn commit
To apply a pending Registered State Change Notification (RSCN) configuration, use the rscn commit
command. To discard a pending RSCN configuration, use the no form of the command.
Syntax Description
vsan vsan-id
Command Default
None
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines If you commit the changes made to the active database, the configuration is committed to all the switches
in the fabric. On a successful commit, the configuration change is applied throughout the fabric and the
lock is released.
Examples
The following example commits an RSCN configuration on VSAN 1:
switch(config)# rscn commit vsan 1
Related Commands Command
rscn abort
rscn distribute
rscn event-tov
clear rscn session
show rscn
Cisco Nexus 5000 Series Command Reference
8-124
rscn commit vsan vsan-id
no rscn commit vsan vsan-id
Specifies a VSAN where the RSCN configuration should be committed. The
ID of the VSAN is from 1 to 4093.
Modification
This command was introduced.
Description
Cancels a pending RSCN configuration on a specified VSAN.
Enables the distribution of an RSCN configuration.
Configures an RSCN event timeout.
Clears the RSCN session for a specified VSAN.
Displays RSCN configuration information.
Chapter 8 Fibre Channel Commands
OL-16599-01