Deadtime - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 6 Security Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

deadtime

To configure the dead-time interval for a RADIUS or TACACS+ server group, use the deadtime
command. To revert to the default, use the no form of this command.
Syntax Description
minutes
Command Default
0 minutes.
Command Modes RADlUS server group configuration
TACACS+ server group configuration
Command History Release
4.0(0)N1(1a)
Usage Guidelines
You must use the feature tacacs+ command before you configure TACACS.
Examples This example shows how to set the dead-time interval to 2 minutes for a RADIUS server group:
switch(config)# aaa group server radius RadServer
switch(config-radius)# deadtime 2
This example shows how to set the dead-time interval to 5 minutes for a TACACS+ server group:
switch(config)# aaa group server tacacs+ TacServer
switch(config-tacacs+)# deadtime 5
This example shows how to revert to the dead-time interval default:
switch(config)# aaa group server tacacs+ TacServer
switch(config-tacacs+)# no deadtime 5
Related Commands Command
aaa group server
feature tacacs+
radius-server host
OL-16599-01
deadtime minutes
no deadtime minutes
Number of minutes for the interval. The range is from 0 to 1440 minutes.
Setting the dead-time interval to 0 disables the timer.
Modification
This command was introduced.
Description
Configures AAA server groups.
Enables TACACS+.
Configures a RADIUS server.
Cisco Nexus 5000 Series Command Reference
deadtime
6-13