Use-Vrf - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 6 Security Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

use-vrf

To specify a virtual routing and forwarding instance (VRF) instance for a RADIUS or TACACS+ server
group, use the use-vrf command. To remove the VRF instance, use the no form of this command.
Syntax Description
vrf-name
Command Default None
Command Modes RADlUS server group configuration
TACACS+ server group configuration
Command History Release
4.0(0)N1(1a)
Usage Guidelines You can configure only one VRF instance for a server group.
Use the aaa group server radius command RADIUS server group configuration mode or the aaa group
server tacacs+ command to enter TACACS+ server group configuration mode.
If the server is not found, use the radius-server host command or tacacs-server host command to
configure the server.
You must use the feature tacacs+ command before you configure TACACS+.
Examples This example shows how to specify a VRF instance for a RADIUS server group:
switch(config)# aaa group server radius RadServer
switch(config-radius)# use-vrf management
This example shows how to specify a VRF instance for a TACACS+ server group:
switch(config)# aaa group server tacacs+ TacServer
switch(config-tacacs+)# use-vrf management
This example shows how to remove the VRF instance from a TACACS+ server group:
switch(config)# aaa group server tacacs+ TacServer
switch(config-tacacs+)# no use-vrf management
OL-16599-01
use-vrf vrf-name
no use-vrf vrf-name
Specifies VRF instance name.
Modification
This command was introduced.
Cisco Nexus 5000 Series Command Reference
use-vrf
6-143