Modem Init-String - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

modem init-string

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
modem init-string
To download the initialization string to a modem connected to the console port, use the modem
init-string command. To revert to the default, use the no form of this command.
Syntax Description
default
user-input
Command Default The default initialization string is ATE0Q1&D2&C1S0=1\015.
Command Modes
Terminal line configuration
Command History Release
4.0(0)N1(1a)
Usage Guidelines You can configure the console port only from a session on the console port.
The default initialization string ATE0Q1&D2&C1S0=1\015 is defined as follows:
•
•
•
•
•
•
•
Use the modem set-string command to configure the user-input initialization string.
Examples This example shows how to download the default initialization string to the modem connected to the
console port:
switch# configure terminal
switch(config)# line console
switch(config-console)# modem init-string default
Cisco Nexus 5000 Series Command Reference
1-56
modem init-string {default | user-input}
no modem init-string
Downloads the default initialization string.
Downloads the user-input initialization string.
Modification
This command was introduced.
AT—Attention
E0 (required)—No echo
Q1—Result code on
&D2—Normal data terminal ready (DTR) option
&C1—Enable tracking the state of the data carrier
S0=1—Pick up after one ring
\015 (required)—Carriage return in octal
Chapter 1 Basic System Commands
OL-16599-01