Npv Traffic-Map Server-Interface - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

npv traffic-map server-interface

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
npv traffic-map server-interface
To configure the server interface based trafic engineering, use the npv traffic-map server-interface
command in configuration mode. To revert to the default value, use the no form of the command.
Syntax Description if-range
Defaults
None.
Command Modes Configuration mode.
Command History Release
3.3(1a)
Usage Guidelines
None.
Examples
The following example shows how to configure NPV traffic map server interface:
switch(config)# npv traffic-map server-interface fc1/1 external-interface fc1/2
switch(config)# npv traffic-map server-interface fc1/4-5 external-interface fc1/6-7
switch(config)# no npv traffic-map server-interface fc1/4-5 external-interface fc1/6-7
switch(config)# no npv traffic-map server-interface fc1/1 external-interface fc1/2
switch(config)#
Related Commands Command
show npv-traffic-map
Cisco MDS 9000 Family Command Reference
16-10
npv traffic-map server-interface <if -range> external-interface <if-range>
no npv traffic-map server-interface <if -range> external-interface <if-range>
Modification
This command was introduced.
Description
Displays information about the NPV traffic map.
Range may vary from <1-1>.
Chapter 16 N Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x