Logging Event Link-Status Global (Global Configuration) - Cisco Catalyst 4500 Series Command Reference Manual

logging event link-status global (global configuration)

logging event link-status global (global configuration)
To change the default switch-wide global link-status event messaging settings, use the
logging event link-status global command. Use the no form of this command to disable the link-status
event messaging.
Syntax Description
This command has no arguments or keywords.
Defaults
The global link-status messaging is disabled.
Command Modes Global configuration mode
Command History Release
12.2(25)SG
Usage Guidelines
If link-status logging event is not configured at the interface level, this global link-status setting takes
effect for each interface.
Examples
This example shows how to globally enable link status message on each interface:
Switch# config terminal
Enter configuration commands, one per line.
Switch(config)# logging event link-status global
Switch(config)# end
Switch#
Related Commands Command
logging event link-status (interface
configuration)
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
2-382
logging event link-status global
no logging event link-status global
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
End with CNTL/Z.
Description
Enables the link-status event messaging on an interface.
OL-25342 -01