DC SC2020
Version 1.1
Figure 6 j0bs65017
•
Color Bar Screen
Figure 7 j0bs65018
•
Grayscale Screen
Figure 8 j0bs65019
6.5.11.3 Operating Explanation
•
Move to the next screen with the [Start] key. Go back to the previous screen with the [Stop] key.
(The display shall be all Red when entering from the Menu and the it shall return to the Panel Diag
Menu when the [Start] key is pressed at the Grayscale screen.)
•
Return to the Panel Diag Menu using the [Delete] key.
05/2014
6-276
6.5.12 Adjust Sense of Touch
6.5.12.1 Function Explanation
•
Acquire the PD4 (Y coordinate) voltage during the touch operation of the Panel and set the adjust-
ment value for determining whether the acquired value is standard value or above.
•
Maintain the adjusted value in NVM of the Touch Panel Device.
•
When touch operating the Panel, use the adjusted value that was set with this device and detect the
touch.
6.5.12.2 Screen Layout
NOTE: The default value is 2801.
6.5.12.3 Operating Explanation
•
Sensitivity adjustment value can be changed only with the numeric keypad.
•
The value range is from 0 (low) to 915 (high). If a number that exceeds the maximum value is
entered, the numeric keypad input will be invalid.
•
Set the value with the [OK] button/[Start] key and return to the Panel Diag Menu. The [x] button/
[Delete] key will not set the value and will return to the Panel Diag Menu.
•
Return the sensitivity to its default value by pressing the [All Clear] key.
6.5.12 Adjust Sense of Touch
Figure 1 j0bs65020
General