Ibt Unit Near End Warning; 2Nd Btr Unit Near End Warning; Ibt Unit End Warning; 2Nd Btr Unit End Warning - Fuji Xerox DocuCentre SC2020 Service Manual

094-417 IBT Unit Near End Warning

BSD-ON:-
Generate Fail if NVM(IBT Unit current counter) is greater than the value subtracted NVM(PV until IBT
Unit replacement warning) from NVM(IBT Unit Life).
Cause/Action
Prepare a new IBT Belt Unit as the replacement time of the IBT Belt Unit is approaching. In addition,
replace the IBT Belt Unit as necessary. (PL
After replacing, enter CE Mode, go to Printer Diag > Parameter > Life > IBT Unit and initialize the Life
Counter.

094-419 2nd BTR Unit Near End Warning

BSD-ON:-
Generate Fail if NVM(2nd BTR Unit current counter) is greater than the value subtracted NVM(PV until
2nd BTR Unit replacement warning) from NVM(2nd BTR Unit Life).
Cause/Action
Prepare a new 2nd BTR Roll as the replacement time of the 2nd BTR Roll is approaching. In addition,
replace the 2nd BTR Roll as necessary. (PL
After replacing, enter CE Mode, go to Printer Diag > Parameter > Life > 2nd BTR Unit and initialize the
Life Counter.

094-420 IBT Unit End Warning

BSD-ON:-
Generate Fail when NVM (IBT Unit current counter) becomes greater then NVM (IBT Unit Life).
Cause/Action
Replace the IBT Belt Unit if necessary since it has reached the time to replace the IBT Belt Unit.
After replacing, enter CE Mode, go to Printer Diag > Parameter > Life > IBT Unit and initialize the Life
Counter.

094-422 2nd BTR Unit End Warning

BSD-ON:-
Generate Fail when NVM (2nd BTR Unit current counter) becomes greater then NVM (2nd BTR Unit
Life).
Cause/Action
Replace the 2nd BTR Roll if necessary since it has reached the time to replace the 2nd BTR Roll.
6.1)
Version 1.1
DC SC2020
6.1)
6.1)
After replacing, enter CE Mode, go to Printer Diag > Parameter > Life > 2nd BTR Unit and initialize the
Life Counter.

094-911 IBT Unit Life End

BSD-ON:-
Generate Fail when NVM (IBT Unit current counter) becomes greater then NVM (IBT Unit Dead End gen-
erated PV).
Cause/Action
Replace the IBT Belt Unit (PL
After replacing, enter CE Mode, go to Printer Diag > Parameter > Life > IBT Unit and initialize the Life
Counter.
(PL 6.1)
(PL
05/2014
2-103
6.1)

CHAIN 94

Troubleshooting