Table of Contents
Advertisement
DC SC2020
Version 1.1
6.5.5.2 Screen Layout
Figure 1 j0bs65004
6.5.5.3 Operating Explanation
•
Display the character string that corresponds to the Hardware Key and change the corresponding
character string color to Dark Green while the Hardware Key is being pressed.
The pressed Hardware Key will change the corresponding character string letters to Orange.
•
Support simultaneous pressing of the Hardware Key as well, and if simultaneous pressing is
detected, change the corresponding multiple character string letter to Red (Even if it has already
been pressed, change to Red when multiple pressing occurs).
•
Return to the Panel Diag Menu using the [<-] button.
•
Display the character string of the energy saving key in Gray.
05/2014
6-272
6.5.6 Adjust Touch Screen Test
6.5.6.1 Function Explanation
•
Set the correction value of the Touch Panel.
•
Use a 3-point calibration method for the 4.3inch Touch Panel.
6.5.6.2 Screen Layout
1.
1. Switch to the Touch Correction Screen if the Menu is selected.
2.
The color is changed if the "+" mark is touched.
6.5.6.3 Operating Explanation
•
Return to the Panel Diag Menu when the [Delete] key of the Hardware Key is pressed.
•
Proceed to the Touch Screen Test screen after touching the last mark (First & middle marks need to
be touched before).
•
Display the touched coordinate with a red "+" mark in the Panel Diag and CE Diag.
(In most cases, do not display if it was started up from the Maintenance Menu.)
6.5.6 Adjust Touch Screen Test
Figure 1 j0bs65005
Figure 2 j0bs65006
General
Advertisement
Chapters
Table of Contents
Troubleshooting
