DC SC2020
Version 1.1
REP 10.6.2 (SCC) STM Takeaway Motor
Parts List on
PL 10.6
Removal
WARNING
When turning OFF the power switch, check that the "Data"
lamp is OFF and that there is no Job in progress.
Turn OFF the Power Switch and make sure that the screen dis-
play or energy-saving LED is turned off.
Check that the power switch is OFF and unplug the power plug.
CAUTION
Static electricity may damage electrical parts.
Static electricity may damage electrical parts. Always wear a wrist
band during servicing. If a wrist band is not available, touch some
metallic parts before servicing to discharge the static electricity.
1.
Remove the STM Rear Cover. (Figure 1)
(1) Remove the Docking Screw.
(2) Remove the Docking Bracket.
(3) Remove the screw (x2).
(4) Remove the STM Rear Cover.
Figure 1 j0bs41014
2.
Remove the STM Takeaway Motor. (Figure 2)
(1) Disconnect the connector.
(2) Remove the Screw (Round Point: x2).
(3) Remove the STM Takeaway Motor.
05/2014
4-54
Figure 2 j0bs41017
Replacement
1.
To install, carry out the removal steps in reverse order.
Disassembly/Assembly and Adjustment
10. One Tray Module (Tray 2)