Rep 2.1.2 Lph (Y, M, C, K) - Fuji Xerox DocuCentre SC2020 Service Manual

Hide thumbs Also See for DocuCentre SC2020:

Table of Contents

Figure 17 j0bs40215

When installing the LPH and Marking Guide, insert the Rear

Frame of the Marking Guide into the mounting hole. (Figure 18)

Figure 18 j0bs40216

When installing the FFC Cable Guide, insert the Hook (2) of the

FFC Cable Guide into the mounting hole. (Figure 19)

Figure 19 j0bs40203

When connecting the FFC Cable (M, Y, K, C), insert the FFC

Cable straightly into the Connector Housing until you hear the

Lock sound. (Figure 20)

Figure 20 j0bs41810

Disassembly/Assembly and Adjustment

REP 2.1.2 LPH (Y, M, C, K)

Parts List on

When turning OFF the power switch, check that the "Data"

lamp is OFF and that there is no Job in progress.

Turn OFF the Power Switch and make sure that the screen dis-

play or energy-saving LED is turned off.

Check that the power switch is OFF and unplug the power plug.

To prevent the light fatigue of the Drum, either wrap the removed

Xero Unit by using a sheet of black paper or store it in a black bag.

NOTE: Because the removal procedure for the LPH (Y, M, C, K) is

the same, the following describes only the procedure for the LPH

NOTE: Place the drop cloth or newspapers at the servicing area to

keep the site clean.

Prepare a sheet of black paper (x4) or a black bag (x4).

Remove Y,M,C,K of the Xero Unit.

Remove the Deve Unit of Y,M,C,K.

Remove the IBT Belt Unit.

Remove the Front Cover.

LPH (Y) Only: Remove the Right Cover.

LPH (Y) Only: Remove the HVPS.

Remove the Screws that secure the LPH (K). (Figure 1)

(1) Remove the screw.

Table of Contents