Transfer; Rep 6.1.1 Ibt Belt Unit - Fuji Xerox DocuCentre SC2020 Service Manual

REP 6.1.1 IBT Belt Unit

Parts List on PL 6.1
Removal
WARNING
When turning OFF the power switch, check that the "Data"
lamp is OFF and that there is no Job in progress.Turn OFF the
Power Switch and make sure that the screen display or energy-
saving LED is turned off.Check that the power switch is OFF
and unplug the power plug.
NOTE: Place the drop cloth or newspapers at the servicing area to
keep the site clean.
NOTE: Close the Main Unit Cover and work when the IBT Belt Unit
is removed. To prevent Drum from light fatigue.
NOTE: Do not touch the IBT Belt surface.
1. Open the Front Cover.
2. Remove the Waste Bottle. (Figure 1)
(1) Turn the Retract Handle in counterclockwise direction.
(2) Release the hook (x2).
(3) RRemove the Waste Bottle.
Figure 1 j0bs40813
3. Open the L/H Cover.
4. Remove the Screw that secures the IBT Belt Unit. (Figure 2)
(1) Remove the screw (x2).
Version 1.1
DC SC2020
Figure 2 j0bs40601
5. Remove the IBT Belt Unit. (Figure 3)
(1) Hold the Handle A and pull out the IBT Belt Unit where
Handle B can be seen.
(2) Hold the Handle B and Right Side Housing and remove
the IBT Belt Unit.
Figure 3 j0bs40602
6. Replace with IBT Belt Unit in the Replacement Kit.
Replacement
1. When installing the IBT Belt Unit, make sure the Retract Han-
dle is in the position as shown in the figure. (Figure 4)
05/2014
4-29
Figure 4 j0bs40603
2. Return the IBT Belt Unit to the original state.
3. Close the L/H Cover.
4. Return the Waste Bottle to the original state.
5. Close the Front Cover.
6. Enter the CE Mode after installation and initialize Printer Diag >
Parameter > Life > IBT Unit and initialize the Life Counter.
NOTE: The Life Counter initialization must be performed. If the
Life Counter is not initialized, it may result in poor image quality
and even a malfunction of the machine.
7. Perform "1st BTR Initialize" with Digital Output.
• Perform Chain Link [042-009]"1st BTR Initialize" with CE
Mode > Printer Diag > IOT Diag > Digital Output.
Stop after performing the drive switching operation during
initialization with starting instruction.
NOTE: The 1st BTR Initialization must be performed. If this is
not performed, it may result in poor image quality and even a
malfunction of the XERO ERU.
Disassembly/Assembly and Adjustment

6. Transfer