Fuji Xerox DocuCentre SC2020 Service Manual page 411

6.1.11 Warm Up Time
The time required before a print operation can be performed after the power is turned on is as follows.
Measurement Rated at 20 degrees C/65% RH.
Conditions Toner Recovery and Setup Cycle are not included.
Power ON after seasoning when the power has been OFF for 3 hours or longer.
Basic Configura- Standard Main Unit
tion
Table 2
Configuration Immediately after main power is turned ON*1
APO 39sec or less*1
*1: "Time from Power on to Standby on UI" or "Time from Power on to print out one sheet" - "Time from
Standby to print out one sheet"
Version 1.1
DC SC2020
Table 1
6.1.12 FCOT
<Definition>
The time that is required since the <Start> button is pressed until the trail edge of paper is output to the
defined output destination.
The measurement result is rounded to the first decimal place.
• Prerequisite
Item Contents
Document/Paper Size/Orienta- A4 LEF Document, A4 LEF Paper
tion Document size must be detected before the Start button is
pressed.
IIT/DADF Status If the Platen is used, the document size is detected when the
Platen Cover is closed.
When using the DADF, the document must already be loaded.
Tray Used Tray 1
Copy Side Settings 1->1 Sided Copy
Paper Quality Settings Plain
Quantity Settings 1 set
Reduce / Enlarge 100% (excluding the case of 100% Fine Adjustment)
Output Color Listed in Table 2
Output Tray Output Tray
Output Orientation Rear output (output orientation not specified)
State of Fusing Unit The Fusing Unit must be in the Ready state
State of 1st BTR 1stBTR is Contact for Color priority, 1stBTR is Retract for
Black&White priority (Default)
State of the LPH LPH must be in the Ready state
UI 4.3" WQVGA Color UI
Others Other application functions or optional functions must not be set.
Background Suppression OFF
ACC OFF Auto Color Correction
• 20 ppm model FCOT
Document Set
No. Platen/DADF Output Tray
1 Platen Output Tray
2 Output Tray
05/2014
6-13
Table 1
Table 2
Color Setting
BW FC
Output Setting (PS:126mm/s) (PS:126mm/s)
Black (BW Mode) 8.6 sec or less 11.3 sec or less
Color 10.3 sec or less 10.8 sec or less
6.1.11 Warm Up Time
General