Rep 56.9.1 (Scc) Document Tray - Fuji Xerox DocuCentre SC2020 Service Manual

Hide thumbs Also See for DocuCentre SC2020:

Table of Contents

Figure 4 j0lj45634

10. Remove the DADF Drive Belt. (Figure 5)

(1) Remove the DADF Drive Belt.

Figure 5 j0lj45635

To install, carry out the removal steps in reverse order.

REP 56.9.1 (SCC) Document Tray

Parts List on

When turning OFF the power switch, check that the 'Data' lamp

is OFF and that there is no Job in progress.

Turn OFF the power switch and make sure that the screen dis-

play or the Power Saver LED turns OFF.

Check that the power switch is OFF and unplug the power plug.

Remove the DADF Front Cover.

Remove the DADF Rear Cover.

Remove the wire harness of the Document Tray from the Har-

ness Guide. (Figure 1)

(1) Disconnect the connector (x4).

For the type that comes with DADF Open Sensor,

disconnect the connector of the DADF Open Sensor.

(2) Remove the wire harness from the Harness Guide.

Figure 1 j0lj45614

Reference: This shows the removed wire harness of the Docu-

ment Tray. (Figure 2)

Remove the boss of the Document Tray at the front. (Figure 3)

(1) Squeeze the boss of the Document Tray in the direction of

the arrow and remove it from the hole.

Remove the wire harness through the hole at the rear. (Figure

(1) Remove the wire harness through the hole.

Disassembly/Assembly and Adjustment

Figure 2 j0lj45615

Figure 3 j0lj45616

Table of Contents