Fuji Xerox DocuCentre SC2020 Service Manual page 245

(1) Move the Inside Shutter towards the arrow direction.
Figure 8 j0bs40817
15. Extract the Toner on the paper from the Toner Cartridge Out-
put. (Figure 9)
Figure 9 j0bs40818
16. Apply the extracted Toner to the edge of the Drum Blade in the
Replacement Kit by using KimWipes or BEMCOT. (Figure 10)
Version 1.1
DC SC2020
NOTE: Apply enough Toner all the way to the both sides of the
Drum Blade.
Figure 10 j0bs40814
17. Replace with Drum Blade with Toner applied. (Figure 11)
(1) Remove the Tapping Screw (x2).
(2) Replace the Drum Blade.
Figure 11 j0bs40806
Replacement
1. Return the Drum to the original state.
2. Return the Sleeve (Front/Rear) to the original state.
3. Return the BCR Housing to the original state.
05/2014
4-43
4. Apply the extracted Toner to the Drum surface by using Kim-
Wipes or BEMCOT. (Figure 12)
• Apply the Toner in the direction of the Drum axis with
approx. 1cm width, turn the Gear towards the direction of
the arrow and spread the Toner on the Drum surface.
Figure 12 j0bs40815
5. Return the Xero Unit to the original state.
6. Return the Waste Bottle to the original state.
7. Close the Front Cover.
Disassembly/Assembly and Adjustment
8. Xerographic