Fuji Xerox DocuCentre SC2020 Service Manual page 619

Figure 2 j0bs64059
3. Press the [<--] (Back) button to return to the [Printer Diag] screen.
Figure 3 j0bs64058
4. Exit the CE mode. (See "6.4.4 How to Exit the CE Mode".)
Version 1.1
DC SC2020
6.4.10 Installation Settings
Display/set/clear the following parameter.
Depending on the item, it can be displayed/set, only to display, or only to clear.
Item
Serial No.1
Serial No.2
Serial No.3
Product No.1
Product No.2
Product No.3
HexDump
Tone Correction (IOT
tone control)
Pixel Counter
Configuration Dip Switch 0
Dip Switch 1
Dip Switch 2
Dip Switch 3
Meter Type
Print Counter Full Color
(Print Service)
Color1
Color2
B/W
Total
Full Color
Backup
Color1 Backup Displays the count backup of the following.- Toner Saver Print
Color2 Backup Displays the count backup of the following.- Specific Color
B/W Backup
05/2014
6-221
Table 1 Installatin Settings
Range Description
9 digits Displays or changes the 9 digits serial number.
ON,OFF Specifies whether HexDump to set to ON or
OFF.
ON,OFF Specifies whether IOT Tone Correction to set
to ON or OFF.
0-100% Displays the last print pixel coverage (%) for
4mm square meter in A4 paper, per Y/M/C/K
color.
- Operates the DIP switches on the NVM in ESS.
Type1~5 Displays the current setup information of the
meter type
Displays the current count of the following.- Normal Full Color
Print Count
Displays the current count of the following.- Toner Saver Print
Count
Displays the current count of the following.- Specific Color
Print Count
Displays the current count of the following.- Normal Mono-
chrome Print Count- Toner Saver Monochrome Print Count-
Report Print Count
Displays the total count of the full color print and themono-
chrome print.
Displays the current count of the following.- Full Color Print
Count Backup
Count Backup
Print Count Backup
Displays the count backup of the monochrome print.
6.4.10 Installation Settings
General