Fuji Xerox DocuCentre SC2020 Service Manual page 259

Figure 6 j0lj41310
8. Move the housing to the tip of the shaft. (Figure 7)
(1) Remove the Bearing.
(2) Remove the E-Clip.
(3) Move the housing in the direction of the arrow until it is at
the tip of the shaft.
Figure 7 j0lj41311
9. Remove the MSI Feed Roll. (Figure 8)
(1) Remove the gear.
(2) Remove the MSI Feed Roll.
Version 1.1
DC SC2020
Figure 8 j0lj41312
Replacement
1. To install, carry out the removal steps in reverse order.
2. When installing the MSI Feed Clutch, align the Cutout of the
MSI Feed Clutch to the Tab. (Figure 9)
Figure 9 j0lj41313
3. When installing the MSI Top Cover, store the Link of the Paper
Stopper Lock underneath the Boss of the MSI Feed Roll Hous-
ing. (Figure 10)
• After installing the MSI Top Cover, check from the hole of
the MSI Top Cover to make sure that the Link is under-
neath the Boss..
05/2014
4-57
Figure 10 j0mg41301
4. After a replacement, enter the CE mode, and then perform Ini-
tialize via Printer Diag > Parameter > Life > MSI FR Pad to ini-
tialize the Life counter.
Disassembly/Assembly and Adjustment
13. MSI