DC SC2020
Version 1.1
Figure 4 j0mg91025
9.
[Machines with One Tray Module]: Remove the STM Connector Cover. (Figure 5)
(1) Remove the screw.
(2) Remove the STM Connector Cover.
Figure 5 j0bs41901
10. [Machines with One Tray Module]: Disconnect the connector. (Figure 6)
(1)
Remove the cable band.
05/2014
9-10
(2) Disconnect the connector.
11. Remove the Rear Cover. (Figure 7)
(1) Remove the screw.
(2) Remove the Blind Cover.
(3) Remove the Docking Screw.
(4) Remove the Docking Bracket.
(5) Remove the screw (x8).
(6) Remove the Rear Cover.
12. Connect the wire harness of the DADF. (Figure 8)
(1) Connect the connector.
(2) Install the cable band.
Installation/Removal
Figure 6 j0bs41902
Figure 7 j0bs91025
9.1.2 DADF