Rep 18.2.2 (Scc) Ess Pwb - Fuji Xerox DocuCentre SC2020 Service Manual

DC SC2020
Version 1.1
(2) Check to see if the FFC Cable on the side that is not
inserted and removed is definitely connected.
Figure 4 j0bs41804
05/2014
4-68

REP 18.2.2 (SCC) ESS PWB

Parts List on PL 18.2
Removal
WARNING
When turning OFF the power switch, check that the "Data"
lamp is OFF and that there is no Job in progress.
Turn OFF the Power Switch and make sure that the screen dis-
play or energy-saving LED is turned off.
Check that the power switch is OFF and unplug the power plug.
CAUTION
Static electricity may damage electrical parts.
Static electricity may damage electrical parts. Always wear a wrist
band during servicing. If a wrist band is not available, touch some
metallic parts before servicing to discharge the static electricity.
CAUTION
Do not get yourself hurt by a soldered portion on the back of the
PWB.
1. Remove the Rear Cover. (REP 19.1.5)
2. Disconnect the FFC CD Cable. (Figure 1)
(1) Push Buttons (x2) simultaneously towards the direction of
the arrow and straightly remove the FFC Cable.
Figure 1 j0bs41805
3. Remove the FFC Cable (x4) connection in the order of FFC
Cable C, K, Y, M. (Figure 2)
(1) Push Buttons (x2) simultaneously towards the direction of
the arrow and straightly remove the FFC Cable.
Disassembly/Assembly and Adjustment
Figure 2 j0bs41806
4. Disconnect the connector. (Figure 3)
(1) Disconnect the connector (x7).
Figure 3 j0bs41807
5. Remove the Screw that secures the ESS PWB on the Right
side. (Figure 4)
(1) Remove the screw.
18. Electrical