Detailed Contents Of The Service Call; Trim Check List - Fuji Xerox DocuCentre SC2020 Service Manual

DC SC2020
Version 1.1

1.3 Detailed Contents of the Service Call

1.3.1 Initial Actions
1. Ask the operator(s) about the machine condition.
• How often and where do paper jams have been occurring recently
• How is the copy quality
2. Record the copy meter readings.
3. Inspect any error copies, then check the machine.
4. Check the print samples from previous service calls and the Service Log.
1.3.2 Checking Reproducibility of Problem
1. Check the problem status by performing the Level 1 Troubleshooting in [Chapter 2 Troubleshoot-
ing].
2. Perform the applicable Level 2 Troubleshooting FIP in [Chapter 2 Troubleshooting].
3. If there are no applicable items, troubleshoot by referring to [Chapter 7 BSD].
1.3.3 Checking Copy Quality
1. Make several sheets of copies using the Test Chart (499T 00247), then check the quality of the cop-
ies.
1.3.4 TRIM Servicing
Perform TRIM servicing during a service call to maintain the machine performance.
1. Follow the TRIM Check List to perform the required TRIM items.
2. Check for parts that require periodical cleaning/replacement (consumables, parts) by referring to the
TRIM Chec List, the Periodic Replacement Parts/Consumables List, and the Maintenance Report,
and clean them if necessary. If a replacement is done, make sure that you enter the CE Mode and
use Printer Diag > Parameter > Life to clear the applicable counter(s).
05/2014
1-6

1.4 TRIM Check List

C: Perform checking. Clean, replace, or feed if necessary.
O: Always perform cleaning and checking.
*: Always perform replacement service at the specified interval.
Every
No. Servicing Items time
1.1 Pre-servicing Check C
(Check the machine oper-
ation sound)
1.2 Pre-servicing Check C
(Copy and print the Test
Chart)
2 Clean the interior of the C
machine
(Clean the paper transport
system)
3 Cleaning the IIT C
4 Clean the DADF C
5 Safety Check O
6.1 Post-servicing check C
(Copy Quality Check)
6.2 Post-servicing check C
(Check the machine oper-
ation)
6.3 Post-servicing check C
(Check the meter)
Service Call Procedure
1.3 Detailed Contents of the Service Call
Table 1
Service Details
• Activate the machine and check that abnormal noise is
not heard.
• Make several sheets of copies using the Test Chart
(499T 00247), then check the quality of the copies.
• Clean any paper dust and toner residue in the paper
path and on the jam sensor.
• Especially, clean the operation section of the operator
carefully.
• Clean the Platen Glass surface and the Platen Cushion
with the optical cleaning cloth.
• Clean the Reflector, back of the Platen Glass, mirrors
and lens with the optical cleaning cloth.
• Clean the Feed Roll, Nudger Roll, and Retard Roll with
a cloth that has been wrung dry.
• Clean the DADF Platen Glass with the optical cleaning
cloth.
• Make sure that the power plug is plugged in properly.
• Make sure that the power cords are not cracked and no
wires are exposed.
• Make sure that no extension cord with insufficient
length or power cord outside the specification, such as
an off-the-shelf power strip, is being used.
• Make sure that a single socket does not have multiple
power plugs plugged into it.
• Make several sheets of copies using the Test Chart
(499T 00247), then check if the quality satisfies the
specification.
• Check the paper feed and abnormal noise.
• Create the Service Log and Service Report.