Fuji Xerox DocuCentre SC2020 Service Manual page 662

DC SC2020
Version 1.1
Table 1 DADF Component Check Input
Chain Link Parameter
005 206 CVT Pre-Reg. Sensor
005 211 CVT Invert Sensor
005 212 CVT Feeder Cover Interlock Switch
005 213 DADF Open Sensor
005 215 CVT #1 Tray APS Sensor
005 216 CVT #2 Tray APS Sensor
005 217 CVT #3 Tray APS Sensor
005 221 CVT Tray Size SNR No.1
005 222 CVT Tray Size SNR No.2
005 224 ScanStart
005 228 APS
6.4.16.7.2 DADF IIT Output
Procedure
1. Use the [Down arrow] button to select [DADF Component Check], and press the [OK] button.
Figure 4 j0bs64185
2. Use the [Down arrow] button to select [DADF IIT Input], and press the [OK] button.
Figure 5 j0bs64188
3. Press the [OK] button.
05/2014
6-264
4. Press the [OK] button.
Table 2 DADF Component Check Output
Chain Link Parameter
005 004 CVT Feed Motor
005 005 CVT Feed Motor
005 008 CVT Feed Motor
005 010 CVT Feed Motor
005 046 CVT Platen Motor
005 047 CVT Platen Motor
005 048 CVT Exit. Motor
005 049 CVT Exit. Motor
005 062 CVT Feed Clutch
005 072 CVT Nip Release Sol
005 083 Doc Ready
005 088 Image Area ON
005 098 TA Clutch
6.4.16.7 DADF Component Check
Figure 6 j0bs64189
Figure 7 j0bs64191
General