Fuji Xerox DocuCentre SC2020 Service Manual page 817

NOTE: When removing the Rear Cover from the box, make sure that 2 persons hold the cover as
shown. (Figure 2)
Figure 2 j0bs91064
3. Turn OFF the Power Switch and make sure that power-saving LED and screen display turn OFF.
When turning OFF the power switch, check that the "Data" lamp is OFF and that there is no Job in
progress.
4. Unplug the power plug.
When maintaining the machine, turn OFF the power switch and unplug the power plug.
5. Disconnect all cables that are connected to the right of the IOT.
6. Remove the Rear Cover. (Figure 3)
(1) Remove the screw (x8).
(2) Remove the Rear Cover.
Version 1.1
DC SC2020
CAUTION
WARNING
7. Install Wire Harness in the kit to Bracket in the kit. (Figure 4)
(1) Add Connector Housing of Wire Harness to Bracket.
(2) Secure the wire harness by using Cableband.
8. Install Bracket and Wire Harness. (Figure 4)
(1) Attach Bracket and Wire Harness.
(2) Secure it by using the screw (x2) that are provided in the Kit.
05/2014
9-19
Figure 3 j0bs91031
Figure 4 j0bs91032
9.1.4 One Tray Module
Installation/Removal