Table C2-16. Valid Options For The Rip_Send_Version Parameter; Rip_Sub_Accept; Rip_Send_Version; Rip_Sub_Advertise - Bay Networks 5390 Administering

rip_send_version

This interface parameter controls the RIP version(s) that the Model 5390 server sends over the IP
interface(s). Table C2-16 describes the valid options for this parameter. The default is compatibility.

rip_sub_accept

This interface parameter controls whether or not subnet routes are accepted over the SLIP, PPP, and
Ethernet interfaces. When enabled, subnet routes are accepted; when disabled, subnet routes are
rejected. A Y enables this parameter, an N disables it. The default is Y.

rip_sub_advertise

This interface parameter controls whether or not the Model 5390 server advertises subnet routes
over the SLIP, PPP, and Ethernet interfaces. When enabled, subnet routes are advertised; when
disabled, subnet routes are not advertised. A Y enables this parameter, an N disables it. The default
is Y.

routed

This Model 5390 parameter determines whether or not the RIP routing daemon is enabled. When
enabled, the Model 5390 server performs active RIP routing only if the option_key parameter is set
to the correct value. If option_key is not set correctly, the Model 5390 server performs only passive
RIP routing when the daemon is enabled. When disabled, no RIP routing occurs. A Y enables this
parameter, an N disables it. The default is Y.
893-741-B

Table C2-16. Valid Options for the rip_send_version Parameter

Option Description
1 Version 1 packets are sent to the broadcast address.
2 Version 2 packets are sent to the RIP multicast address.
compatibility Version 2 packets are sent to the broadcast address.
Configuration Parameters
C2-55