Bay Networks 5390 Administering page 456

Using Model 5390 Security
If you set the port administratively to ipx, npd, auto_detect or auto_adapt, the user is prompted
for a password before being connected to the Model 5390 server. If SecurID times out, the user's
password expires. When the user tries to reconnect using the expired password, FastLink II software
denies access to the Model 5390 server and the user must enter a new password.
For information on configuring SecurID, see Using the SecurID Card on page A15-55.
A15-36
NOTE: SecurID provides password authentication only. Use ACP for
dial-back security or charge-back privileges. The FastLink II software
auto-reconnect feature does not work with SecurID. Normally, by sav-
ing a disrupted session's state (including the user name and password),
FastLink II software can dial the Model 5390 server back and reestab-
lish the user's session where it ended. However, with SecurID, the pass-
word expires before FastLink II software can reconnect the user. The
user receives an error message and must log in again. The Model 5390
server does not support the SecurID Network Loadable Module (NLM).
893-741-B