Bay Networks 5390 Administering page 307

2
Use na, admin, or SNMP to enable active RIP by setting the option_key parameter you
obtained in Step 1.
For example, if your key value is RaqbDwv8e , you would enter the following:
annex: su
Password:
annex# admin
Annex administration Remote Annex R10.1, 24 ports
admin: set annex option_key RaqbDwv8e
Note that the option_key value is case-sensitive.
3
Use na, admin, or SNMP to make sure the Model 5390 parameter routed is set to Y. If it is
not, set it to Y.
For example, at the CLI superuser level, invoke admin, issue the show annex command
including the routed parameter, and, if routed is set to N, issue the set annex command:
admin: show annex routed
routed: N
admin set annex routed Y
:
4
Reboot the Model 5390 server to put the routed and option_key settings into effect:
admin: q
annex# boot
893-741-B
Internet Protocol (IP) Routing
A12-49