Bay Networks 5390 Administering page 816

Software Reference
Table D1-1. All Parameters (continued)
Parameter
timezone_minuteswest
tmux_delay
tmux_enable
tmux_max_host
tmux_max_mpx
tni_circuit_id
tni_clock
tni_esf_fdl
tni_framing
tni_line_bulldout
tni_line_code
tni_ones_density
D1-20
Values Default
number 300
0–255 ms 20
Y or N N
10–255 64
5–65535 700
string of up to null string
128 characters
loop, local, or Unset
external
ansi or att att
d4 or esf esf
0, 7.5, 15, or 0
22.5
ami or b8zs b8zs
on or off off
Description
Sets the time zone.
Defines the maximum number of
milliseconds during which small packets
can accumulate to form larger packets.
When the time expires, the Model 5390
server sends the multiplexed packet.
Controls whether or not the Model 5390
server uses TMux to multiplex small TCP
packets into a single IP packet.
Specifies the maximum number of host
addresses allowed in the TMux address
table.
Specifies the largest user packet that can be
placed in a TMux packet.
T1 parameter used to store the T1 circuit
identifier string from the service provider.
T1 parameter that controls from where the
T1 clock is set.
T1 parameter used to define the Facilities
Data Link.
T1 parameter that controls which super
frame format is used on the T1Network
Interface.
T1 parameter used to specify the measured
cable loss between the last line generator
and the customer location.
T1 parameter that selects the line code to
be used on the T1 Network Interface.
T1 parameter used to defeat the built-in
ones density monitor.
893-741-B