Bay Networks 5390 Administering page 806

Software Reference
Table D1-1. All Parameters (continued)
Parameter
location
lock_enable
login_password
login_port_password
login_prompt
login_timer
login_timeout
long_break
loose_source_route
map
map_to_lower
map_to_upper
(serial port)
D1-10
Values Default
string ""
Y or N N
<unset> or a <unset>
string
Y or N N
string #
0–60 30
Y or N N
Y or N Y
Y or N Y
map_val Unset
modem_number
Y or N N
Y or N N
Description
Defines a string that represents the port's
location.
Enables any port to use the Model 5390
Interface for VMS Environment's lock
command.
Specifies the password for all ports using a
VMS interface.
Enables the port password when the VMS
command interface is configured (that is,
when cli_interface is set to vci).
Defines the prompt that appears for all
ports using a VMS interface.
Specifies the number of minutes a port
using a VMS interface can remain inactive.
Enables a login timer when the VMS
command interface is configured (that is,
when cli_interface is set to vci).
When enabled, the Model 5390 server
returns the user to the CLI prompt after
receiving a break greater than two seconds.
Allows the Internet protocol to use loose
source routing.
T1 parameter that controls the mapping of
the modem, Drop/Insert interface, and T1
Network Interface.
Enables/disables case conversion (from
upper to lower) for characters sent from
the terminal to the Model 5390 server.
Enables/disables case conversion (from
lower to upper) for characters sent from
the terminal to the Model 5390 server.
893-741-B