Bay Networks 5390 Administering page 744

Using the CLI Commands
C3-68
Table C3-28. Setting Parameters Using the stty Command (continued)
Parameter Description
both Specifies both XON/XOFF and CTS/RTS flow control. Both
flow controls are independent. Data flows out of the port only
if CTS is high and the last received XON/XOFF character was
an XON. Receiving XOFF or dropping CTS stops output flow
from the Model 5390 server to the device.
bell Has the same effect as setting the parameter to none.
olower Controls case conversion for characters sent from the
–olower Model 5390 server to the terminal. Setting olower converts
lowercase characters to uppercase. The default, –olower, does
not change case.
ostartc Sets the restart output character. The default is
character
ostopc Sets the stop output character. The default is
character
parity Type of parity checked on input and generated on output.
argument Possible values are: none, even, or odd. The default is none.
prompt code Changes the CLI prompt. The prompt is specified as
alphanumeric characters and embedded formatting codes that
are expanded when the prompt is displayed. The formatting
codes consist of a percent character (%) followed by a single
lower case character. The default is %a%c (annex:). The
formatting codes are:
%a The string annex.
%c A colon followed by a space.
%d The current date and time in standard UNIX format, such as
Mon Mar 14 13:59:42 1988.
%i The Model 5390 IP address.
%j A new line character; skip to the beginning of the next line.
%l The location defined for the port or the string port nn.
%n The Model 5390 name or IP address.
.
CTRL-Q
.
CTRL-S
893-741-B