Map_To_Upper (Asynchronous); Max_Session_Count; Max_Vcli; Metric - Bay Networks 5390 Administering

Configuration Parameters

map_to_upper (asynchronous)

This asynchronous port parameter enables the Model 5390 server to convert lowercase characters
sent to a terminal into uppercase characters. This conversion occurs only at the CLI level. Enable
this parameter for older terminals that do not support uppercase characters. A Y enables this
parameter, an N disables it. The default is N.

max_session_count

This asynchronous port parameter specifies the number of active sessions (jobs) allowed per port.
The allowable values range from 1 to 16. The default is 3.

max_vcli

This Model 5390 parameter determines the maximum number of virtual CLI connections the Model
5390 server can create at a time. Allowable values are the string unlimited or a decimal number
from 0 to 254. A value of 0 prevents any virtual CLI connections. The default is unlimited.

metric

This asynchronous port parameter defines the hop count to the remote end of the asynchronous line
when the mode parameter is set to slip or ppp. Modify this parameter only if you want the Model
5390 server to use a route other than the SLIP or PPP interfaces to the remote end. Allowable values
are 1 to 15. The default is 1.

min_unique_hostnames

This Model 5390 parameter determines whether or not you can identify a host in the host table by
entering a minimal string rather than the full host name. A Y enables minimum uniqueness, an N
disables it. The default is Y.

mode

This asynchronous port parameter sets the mode for access to an asynchronous port. It determines
whether access is initiated by a device connected to the Model 5390 server or from the network
893-741-B C2-37