Bay Networks 5390 Administering page 843

SLIP-specific Asynchronous Port Parameters
Table D1-14 lists SLIP-specific Asynchronous Port parameters.
Table D1-14. SLIP-specific Asynchronous Port Parameters
Parameter
allow_compression
dialup_addresses
do_compression
local_address
metric
remote_address
slip_allow_dump
slip_load_dump_host
slip_mtu_size
slip_no_icmp
slip_ppp_security
slip_tos
subnet_mask
893-741-B
Values Default
Y or N N
Y or N N
Y or N N
Internet 0.0.0.0
address
integer 1
Internet 0.0.0.0
address
Y or N Y
Internet 0.0.0.0
address
small or small
large
Y or N N
Y or N N
Y or N N
Internet 0.0.0.0
subnet
mask
Description
The Model 5390 server uses TCP/IP header
compression if the SLIP link's end point also uses
compression.
Enables/disables requesting dial-up address from
ACP.
Starts TCP/IP header compression on this SLIP
link.
Defines the Internet address for the port
(Model 5390 side of link).
Defines the hop count to the remote end of the
serial line.
Defines the Internet address for the host at the
other end of the serial line.
Enables/disables dumping across a SLIP link.
Defines the host from which the Model 5390
server receives a load or to which the Model 5390
server dumps over the SLIP link.
Forces SLIP interface to use large (1006) or small
(256) maximum transmission units.
Discards any ICMP packets directed to the SLIP
link.
Enables/disables dial-up access via ACP.
When enabled, the Model 5390 server sends
interactive traffic before any other traffic.
Defines an Internet subnet mask for the interface.
Software Reference
D1-47