Bay Networks 5390 Administering page 834

Software Reference
Table D1-10. Asynchronous Port Parameters (continued)
Parameter
dedicated_port
default_session_mode
dialup_addresses
do_compression
echo
erase_char
erase_line
erase_word
forward_key
forwarding_count
forwarding_timer
hardware_tabs
imask_7bits
D1-38
Values Default
telnet, telnet
rlogin, TCP
port number
interactive, interactive
passthru,
passall,
transparent
Y or N N
Y or N N
Y or N Y
control char. ^?
sequence ( key)
DEL
control char. ^U
sequence
control char. ^W
sequence
control char. ""
sequence
0–255 0
0–255, off 0
Y or N Y
Y or N N
Description
Specifies application or TCP port number to
which a dedicated port connects.
Defines the default session mode when the
VMS interface is configured (that is, when
cli_interface is set to vci).
Enables/disables requesting dial-up address
from ACP.
Starts TCP/IP header compression on the SLIP
link.
Enables/disables local character echoing.
Defines the character erase character.
Defines the line erase character.
Defines the word erase character.
Reopens the next available higher numbered
session already established at your port.
When set, the port will not forward received
characters until it receives the specified
number of characters.
Sets the amount of time, in tens of
milliseconds, that will elapse before
forwarding received data.
Allows the terminal to expand ASCII tab
characters if the terminal does not support
hardware tabs.
When enabled, the Model 5390 port ignores
the eighth bit of received characters.
893-741-B