Bay Networks 5390 Administering page 277

To display the values of Model 5390 parameters, use the na or admin command show annex all.
You can also use SNMP.
To set the annex parameter, use the na or admin command set annex (see set Command on page
C1-21).
To define several Model 5390 servers for subsequent set or show annex commands to act on as a
group, use the na command annex (see annex Command on page C1-6).
Activating Model 5390 Parameter Settings
Reboot the Model 5390 server to activate Model 5390 parameter settings.
To display the values of interface parameters, use the na or admin command show interface (see
show Command on page C1-22).
To set an interface parameter, use the na or admin command set interface (see set Command on
page C1-21).
To define several interfaces for subsequent show interface, use the na or admin command interface
(see set Command on page C1-21).
Activating Interface Parameter Settings
To activate interface settings, issue the na or admin reset command – unless you set a parameter
for the Ethernet interface (en0). In the Ethernet case, reboot the Model 5390 server (for more details,
see reset Command on page C1-18 and boot Command on page C1-7).
893-741-B
NOTE: The admin command show annex works the same way as the na
command show annex (see show Command on page C1-22). This is true
for all the na and admin commands in this subsection, except for boot, an
na command you cannot issue from admin. When using admin, return to
the CLI superuser command level to invoke boot (see boot Command on
page C1-7).
Internet Protocol (IP) Routing
A12-19