Configuring Session Parameter Blocks - Bay Networks 5393 User Manual

Once the call type is detected, calls are handled as follows:
• TA and modem calls are placed in protocol-detection mode and
directed accordingly to a PPP, ARAP, or terminal emulation
(CLI) process. Because of its inherent lack of security, SLIP
cannot be detected; it must be started by issuing the slip
command at the CLI prompt.
• Synchronous PPP calls are directed to a PPP process.
For the Remote Annex to be operational with this default configuration,
the only requirements are that you set the switch type and any other
interface parameter whose factory defaults do not match the service
options provided by the telco for your ISDN PRI lines.
Configuring Session Parameter Blocks
You define SPBs in the %pri section of the configuration file on the host
you use to download Remote Annex software. By default, the file is
named config.annex and is located in the /usr/spool/erpcd/bfs directory.
SPB Sections
Each SPB in the %pri section must be defined within begin_session and
end_session fields. The begin_session field lets you name an SPB within
the configuration file.
Release 5.1 Supplement for Remote Annexes
119346-A Rev. A
37