Bay Networks 5390 Administering page 767

To set the emulation mode to VT200 7 bit, enter the following string in an is control
sequence in the portion of termcap that corresponds to the terminal's term_var port
parameter:
\E[62;1"p
To set emulation mode to VT300 7 bit, enter:
\E[63;1"p
• In the section of termcap that corresponds to the term_var port parameter for the terminal,
enter the string
a user invokes tn3270. This allows the user to enter escape sequences by pressing the
single keypad keys listed in map3270.
893-741-B
NOTE: Do not confuse control sequence length with data bits (which
can also be set to 7 or 8 via the setup utility). The latter is a hardware
parameter that specifies the number of bits per character the terminal
transmits. The emulation of one ASCII terminal by another should not
be confused with the emulation of an EBCDIC terminal (for example,
an IBM 3278 terminal) by an ASCII terminal running tn3270.
in an is control sequence to enable Keypad Application mode when
=\E=
NOTE: Because tn3270 does not support the rs control sequence, the
keypad remains in Application mode when the user ends a host session.
Using the CLI Commands
C3-91