Bay Networks 5390 Administering page 836

Software Reference
Table D1-10. Asynchronous Port Parameters (continued)
Parameter
login_timeout
long_break
map_to_lower
map_to_upper
metric
max_session_count
mode
need_dsr
net_inactivity
D1-40
Values Default
Y or N N
Y or N Y
Y or N N
Y or N N
1–15 1
1–16 3
adaptive, cli
arap,
auto-detect,
cli, connect,
dedicated,
ipx, ndp, ppp,
rlogin, slave,
slip, telnet,
tn3270,
unused
Y or N N
Integer or 0 0 (off)
Description
Enables a login timer when the VMS command
interface is configured (that is, when
cli_interface is set to vci).
When enabled, the Model 5390 server returns
the user to the CLI prompt after receiving a
break longer than two seconds.
Enables/disables case conversion (from upper
to lower) for characters sent from the terminal
to the Model 5390 server.
Enables/disables case conversion (from lower
to upper) for characters sent from the terminal
to the Model 5390 server.
Defines the hop count to the remote end of the
serial line.
Specifies the number of active sessions (jobs)
allowed per port.
Sets the mode for access to an asynchronous
port.
For use with a modem connected to a slave
port. When enabled, the connection fails if no
DSR signal is present; when disabled, the
Model 5390 server accepts the connection, but
waits for DSR and DCD before
communicating with the modem.
Defines the amount of time for toll saving
network inactivity.
893-741-B